12/3/2022 0 Comments Configuracion cisco asa 5505Configure it with the IP address and subnet mask provided by your ISP: The outside interface will communicate with the Internet. In order to give your device a hostname and make it easier and more convenient to administer later, use the command “ hostname ”Īt the very minimum, you need to configure two interfaces on your firewall: the outside and the inside. The command “ clear configure all” executed on the firewall leaves only the service lines from factory configuration and you can immediately begin to configure your device afresh. Unlike with Cisco routers, you don’t have to reload the device in order to erase its configuration. To do this, connect using a console cable to the console port of the device, enter the CLI and type:Īfter this confirm the deletion of all configuration files. Lets completely erase the startup configuration of the device. If your new device with factory settings is asking for a password to enter the privileged mode (#) enable, just hit “Enter”. (Should be done only on new or test lab equipment, since it completely erases all existing configuration) Our task: allow the internal LAN hosts to access the Internet through the firewall.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |